隨著釀酒行業的不斷發展，白酒生產朝著規?；蜋C械化方向改動，受到自動化設備的沖擊，家庭釀酒作坊迫切需要改動，因此家用釀酒設備得到了廣泛的應用，當然為了延伸家用釀酒設備的運用壽命，咱們要注重對家用釀酒設備的保養和清洗，接下來就讓咱們一起來了解一下詳細的辦法。
With the continuous development of liquor-making industry, liquor-making is changing in the direction of scale and mechanization. Under the impact of automation equipment, domestic breweries need to be changed urgently. Therefore, domestic breweries have been widely used. Of course, in order to extend the service life of domestic breweries, we should pay attention to the maintenance and cleaning of domestic breweries. Then let's go. Get up and get to know the details.
家用釀酒設備的保養作業：
Maintenance of domestic brewing equipment:
1、在日常的運用中要注意做好它的日常查看，如在運用中發現設備的出水管與設備中進氣管中心的銜接部分呈現漏氣現象，要在時間內及時進行應急處理更換銜接接頭。避免空氣的持續進入。
1. In daily use, we should pay attention to its daily inspection. If we find that the connection part between the outlet pipe of the equipment and the intake pipe center of the equipment is leaking, we should deal with the emergency in time to replace the connection joint. Avoid continuous air entry.
2、在設備中是配備有壓力表和設備閥的，這兩種部件要時常進行查看和養護的，由于這種外表的正常作業對它的發揮出的作用是具有決定性含義的。
2. The equipment is equipped with pressure gauges and safety valves. These two components need to be checked and maintained from time to time, because the normal operation of this appearance plays a decisive role on it.
3、查看氣管與出水管接頭漏氣，當旋緊接頭不問題時，應增加或更換填料，清洗設備時，請用軟毛刷進行沖刷，不要用硬器刮擦。
3. Check the air leakage of the joint between the air pipe and the outlet pipe. When the tightening joint does not solve the problem, the filler should be added or replaced. When cleaning the equipment, please use a soft brush to flush, not scrape with a hard tool.
4、讓設備長時間安穩的保養有利于家用釀酒設備的長時間運用也是非常重要的。
4. It is also very important for the long-term use of domestic brewing equipment to keep the equipment stable for a long time.
家用釀酒設備的清洗辦法：
Cleaning methods for domestic brewing equipment:
1、當釀酒設備裝置結束后進行水洗，用自來水沖刷糖化鍋、過濾槽、沉積槽。沖刷發酵罐時，將自來水管路接在發酵罐排氣閥上，排污閥翻開，沖刷10分鐘。
1. When the brewing equipment is finished, water is washed, and tap water is used to wash the saccharifying pot, filter tank and sedimentation tank. When washing the fermenter, connect the tap water pipeline to the exhaust valve of the fermenter, open the exhaust valve and wash for 10 minutes.
2、進行火堿清洗。在糖化鍋中參加自來水200L左右，再參加3%量的火堿片，進行加熱，溫度達到80-90度。糖化鍋、過濾槽的堿洗經過糖化攪拌器、過濾耕刀及飲料泵的輸送來完成，發酵罐堿洗時，先將飲料泵換熱器發酵罐排污閥之間管道鏈接起來，將火堿水泵入發酵罐，然后用飲料泵將發酵罐中的堿液經過排污管與排氣管進行循環，堿洗20分鐘，再用泵將該發酵罐中的堿液經過排污管打入下一發酵罐，然后進行如上操作。
2. Carry out caustic soda cleaning. In the saccharifying pot, about 200 L of tap water is added, and then 3% pyroalkali tablets are heated, the temperature reaches 80-90 degrees. Alkali washing of saccharifying pot and filter tank is accomplished through the transportation of saccharifying mixer, filter tiller and beverage pump. When the fermentation pot is alkali washed, the pipeline from the beverage pump to the heat exchanger to the sewage valve of the fermentation pot is linked, the caustic soda water is pumped into the fermentation pot, and then the alkali liquid in the fermentation pot is circulated through the sewage pipe and the exhaust pipe with the beverage pump. After alkali washing for 20 minutes, the fermentation pot is fermented by The lye in the tank is fed into the next fermentation tank through the sewage pipe and then operated as above.
家用釀酒設備洗結束，可將堿液放入儲存罐或稀釋排放。假如清洗其它發酵罐時堿液溫度下降的話，應重新回收到糖化鍋重新加溫再進行清洗。
After washing the domestic brewing equipment, alkali liquor can be put into storage tanks or diluted and discharged. If the temperature of lye drops when cleaning other fermentation tanks, it should be reclaimed to the saccharifying pot and reheated before cleaning.
3、用熱水清洗。在糖化鍋中參加自來水足量，進行加熱，溫度達到90-100度。糖化鍋、過濾槽及沉積槽的堿洗經過糖化攪拌機、過濾耕刀及飲料泵的輸送來完成。沖刷死角，需人工沖刷。發酵罐用熱水清洗時，先將飲料泵換熱器發酵罐排氣閥之間的管路鏈接起來，翻開發酵罐的排污閥，沖刷5分鐘。
3. Wash with hot water. In a saccharifying pot, take in enough tap water and heat it up to 90 - 100 degrees. The alkali washing of saccharifying pot, filter tank and sedimentation tank is completed by the transportation of saccharifying mixer, filter blade and beverage pump. Scouring dead corner requires manual scouring. When the fermentation tank is cleaned with hot water, the pipeline from the beverage pump to the heat exchanger to the exhaust valve of the fermentation tank is linked, and the waste discharge valve of the fermentation tank is redeveloped and flushed for 5 minutes.
The above information is our stainless steel inner solid wood barrel finishing and publishing hope to help you all on our website is: http://www.xh191.cn/!
自動售酒機 2024-07-25 
